Process engineering and Design to Value, Built Environment Matters podcast with John Dyson, Professor of Human Enterprise at the University of Birmingham-

Articles:

Always make sure the carpet is completely dry before vacuuming.. Moisture can damage a vacuum cleaner’s motor.

Hold the filter and tap off loose dirt into a bin.You don’t need to whack the filter – a gentle tap is enough!.

Process engineering and Design to Value, Built Environment Matters podcast with John Dyson, Professor of Human Enterprise at the University of Birmingham

If there is still visible dirt on the filter after tapping it off, you’ll need to clean it:.Rinse the filter under a. cold tap.until the water runs clear.

Process engineering and Design to Value, Built Environment Matters podcast with John Dyson, Professor of Human Enterprise at the University of Birmingham

Do not use hot water or any detergent.. Gently squeeze out excess water (not too hard though!).Allow the filter time to.

Process engineering and Design to Value, Built Environment Matters podcast with John Dyson, Professor of Human Enterprise at the University of Birmingham

before replacing it in the bin.

In most cases, we recommended leaving the filter to air dry for around 24 hours.. It’s vital not to put a wet (or even damp) filter back into the Gtech Multi Mk2.You don’t want to accidentally strip the screws, as this makes the battery difficult to remove..

The first screw is located on the rear of the handle.The other two are on found on the bottom of the battery.

Make sure you place the screws in a safe place, as you’ll need them later.. Once each of the screws has been removed, the V10 battery should slide out of the bottom of the vacuum’s handle.Ensure you follow your local laws when disposing of the old battery..

Column classification